Honor 9 Lite EDL Point

The Honor 9 Lite EDL Point is a Point that allows for a connection between a computer and your phone Honor via the EFT dongle, UMT dongle interface, This is done through Emergency Download Mode (EDL). in this guide, I share with you test point for Honor 9 Lite.

if you want to edl mode Honor 9 Lite, you need to find the correct edl test points on the motherboard. and then connect these two points, now your device connected to your Pc.

Emergency Download Mode allows advanced users to gain access to the bootloader of their smartphones, EDL mode typically used for diagnostic and flashing purposes.

Honor 9 Lite Test Point

Honor 9 Lite EDL Point

How to Remove FRP Honor 9 Lite

  • Download and Install Huawei USB Driver
  • Download and Install halabtech tool
  • Power Off your Huawei Honor 9 Lite device
  • Remove the back cover of the your Huawei Honor 9 Lite device
  • Remove Battery Cable
  • Find the Test Point on circuit board
  • you need a Copper Wire to short that pinout.
  • Connect your device to the Computer using a USB cable
  • Now, You Can use halabtech tool to remove FRP.
  • Open halabtech tool and Choose Huawei Tab.
  • On Model choose LLD-L31
  • Choose Reset FRP and Then, Click Refresh
  • Finally, Click Start
  • It’s Done.

Fix Honor 9 Lite edl point not working

  • First, use to original cable USB
  • Then Check driver.
  • Finally, Disconnect the battery and reconnect

How to Remove Huawei ID on Huawei Honor 9 Lite

  • First, Download SigmaKey Software on your Pc.
  • Then, install the SigmaKey Software
  • Connect your Huawei Phone to Computer using a USB Cable
  • Select Serial Port as DBA Adaptor Port and Then, Select the Software Testpoint On Off
  • after that, load the downloaded firmware package “UPDATE.APP”
  • Now, the phone will enter factory mode.
  • Connect your Huawei Device and connecting the USB cable again.
  • Under serial port, Select USB (autodetect)
  • Then, Select Authorize has Huawei
  • Press Remove Huawei ID.

Remove Huawei ID

  • Now, Select the Serial Port as USB (autodetect)
  • Select Authorize has Huawei and then tap the Software Testpoint on/off.

Read More: Vivo Y91 Flash File PD1818F (Stock Rom)

Leave a Comment