Redmi 5 Edl Point

The Redmi 5 Edl Point is a Point that allows for a connection between a computer and your phone xiaomi via the Qualcomm HS-USB QDLoader interface, This is done through Emergency Download Mode (EDL).

if you want to edl mode Xiaomi Redmi 5, you need to find the correct edl test points on the motherboard. and then connect these two points, now your device is connected to your Pc.

We need this method on the Xiaomi Redmi 5 for deleting the Mi account on your Xiaomi Mi Device, flash stock rom or fastboot ROM on your device, and if face any software issues or xiaomi Redmi 5 reboot problems & more.

Emergency Download Mode allows advanced users to gain access to the bootloader of their smartphones, EDL mode typically used for diagnostic and flashing purposes.

Redmi 5 edl point image

redmi 5 edl point

Redmi 5 EDL Point

  • Download & extract Qualcomm QCOM HS-USB QDLoader 9008 Driver on your pc
  • Then, Install the Qualcomm USB driver.
  • Power Off your Redmi 5 device
  • After that, Unlock the Redmi 5 phone back cover.
  • Remove the battery connector.
  • Connect your device to the Computer using a USB cable
  • Then Find EDL Pinout in your Motherboard.
  • Finally, at the same time, you need a Copper Wire to short that pinout + connect the battery connector.

Qualcomm QCOM HS-USB QDLoader 9008 Driver

  • Your phone has now successfully entered EDL mode.

Fix Redmi 5 dead by software Flash

  1. Download & unzip the Redmi 5 Flash ROM
  2. Download and open the Xiaomi Flash tool
  3. Then Click on Select
  4. Choose RedRedmi 5 Flash firmware
  5. Check clean all and lock.
  6. Enter your device to edl mode
  7. Then click on Refresh Flash Tool
  8. Your COM device connected
  9. Finally, click on Flash and wait for the process to be completed.
  10. Congratulation you are done

Reset mi account and remove frp Redmi 5

  1. Download and open UMT Tool  Multi QcFire Tool
  2. Then Click on Read & tools tab.
  3. on Brand choose Xiaomi.
  4. On Model choose Redmi 5
  5. Then Click on Xiaomi special tab.
  6. Check Automatic on boot option.
  7. Then Click on RESET MI ACC.
  8. Click on Yes then wait.
  9. Finally, Would you like to reset FRP, Choose Yes.
  10. It’s Done.

FRP bypass using Hydra Tool

  1. Download and open Hydra Qualcomm tool
  2. Then Choose Sosc
  3. Select the Brand and Module
  4. On the Service, choose Universal
  5. After that, Choose Factory Reset Protection.
  6. Check Auto using Flash Mode.
  7. Connect the Redmi 5 device to the computer
  8. Then Find EDL PinouT, Short two redmi 5 edl point using Copper Wire.
  9. Finally, Wait until the process completed.

How to fix Xiaomi Redmi 5 edl point not working

  • First, use to original cable USB
  • Then Check driver if not going edl 9008 model
  • Finally, Disconnect the battery and reconnect

Read More: Download UFI Box Setup Full Android Tool

Leave a Comment